Glass panel is lifted a bit?

[The_Postman]

Hey there,

so I just got my S9 back from RMA (the glass panel was broken), and it seems they didn't quite put the new one in properly, as the bottom right corner is lifted a bit. It's not too bad, just by pressing on it a bit it went in a little further and stayed there, but it's still a little annoying, and I'm worried bout either dust getting in, or with my luck just plain ripping it off by accident, improbably as it is. So I was wondering if anyone had an idea to keep it in all the way? I was thinking maybe heating it up a bit with a hair dryer and then pushing it in, but I'm not so sure that's good for the device itself. <.<

Help? Thanks. :)

[Uphaillife]

hey there,

so i just got my s9 back from rma (the glass panel was broken), and it seems they didn't quite put the new one in properly, as the bottom right corner is lifted a bit. It's not too bad, just by pressing on it a bit it went in a little further and stayed there, but it's still a little annoying, and i'm worried bout either dust getting in, or with my luck just plain ripping it off by accident, improbably as it is. So i was wondering if anyone had an idea to keep it in all the way? I was thinking maybe heating it up a bit with a hair dryer and then pushing it in, but i'm not so sure that's good for the device itself. <.<

help? Thanks. :)

return and get it new one!

[mybulleturface]

You will get dust in it. Return it.

[the_hero_ricky]

I have the exactly same problem with u